My Tractor Forum banner

Caterpillar Cub Cadet 6284 3 cylinder diesel starting issues

2K views 3 replies 3 participants last post by  Been There Twice 
#1 ·
I have all of the problems starting this as everyone else and am doing the recommended fixes of making sure starter gets full voltage. My problem;
How do I wire in a manual glow plug button/switch and by pass the existing glow plug timer and glow plug relay? I also would like to wire in a starter button.
 
#2 ·
For a manual glow plug you just need a momentary push button and a continuous duty rely. Probably should at least 12 ga wire for the glow plugs from the relay.

Use the same for the starter only you don't need a relay, just find the key start wire on the starter solenoid and run it to the starter button and then to the starter solenoid.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top