[dweber85rc]

What would the rear end out of a 220 with the hydraulic motor weigh about? I am guessing about 120ish each. I am going to pick 2 rear ends with motors out of 220's up to use for my articulated tractor I am building instead of the cub cadet hydro's I originally put in there. The case rear ends will be so much easier to control and no belts or driveshafts to run them either(other than for the hydraulic pump)!

 

[jayvee43]

What would the rear end out of a 220 with the hydraulic motor weigh about? I am guessing about 120ish each. I am going to pick 2 rear ends with motors out of 220's up to use for my articulated tractor I am building instead of the cub cadet hydro's I originally put in there. The case rear ends will be so much easier to control and no belts or driveshafts to run them either(other than for the hydraulic pump)!

Dweb, call them "hydraulic MOTORS" apparently, it offends SOME individuals when we refer to the Hydrive Motors as "pumps" :dunno::dunno::dunno:

As for myself, I don't give a hoot what you call it, as long as you post some pictures, I love these Builds.

Later

Jay

 

[dweber85rc]

Dweb, call them "hydraulic MOTORS" apparently, it offends SOME individuals when we refer to the Hydrive Motors as "pumps" :dunno::dunno::dunno:

As for myself, I don't give a hoot what you call it, as long as you post some pictures, I love these Builds.

Later

Jay

The pump I was referring to is the actual hydraulic pump I have that I am using in this application. :dunno:

 

[chuckbob]

Hi,

I recently boxed a 220 rear with hyd motor in a 3/8 plywood box and took it to UPS for shipping and it weighed 135#.

So without the box 120# is probably close.

Good luck with your project.

chuckbob