My Tractor Forum banner

Case 430 Wheel Question

1266 Views 3 Replies 2 Participants Last post by  DJ54
Hi,

I am posting this in hopes of getting some help for my Dad with a wheel on his 430 Case tractor. He says the rear wheel has splines and clamps on it. Does each one of these clamps need to be adjusted equally? Any help would be appreciated.
Thank you,

Katy
1 - 2 of 4 Posts
I'm assuming it is the type of wheel pictured in the lower half of this exploded view. Official Case IH Online Parts Store and Case IH Catalog for Best Parts Search and Best Parts Look Up. Case IH Parts for Case IH Tractors, Case IH Combines, Case IH Tractors, Case IH Manuals, Case IH Parts

If this is the case, then yes, the bolts should be tightened equally, and best done in an "X" fashion, and in 3 stages, so as not to tighten one side all at once.
You are surely welcome. Hope that is the info you were looking for.
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top