As it says above under load its ok
- It was broken, so I had to fix it...I replaced the carb completely
And I don't believe its supposed to make a popping/misfire sounds on a new carb, so I'm fixing it
Briggs Engine adjusting fuel mixture/idle
I had another thread going on this Sabre mower...it turns out I had to replace the carb on it, so I have a question regarding setting the carb now
I have idles around 1800rpm low/3000 high
It idles great on low
It runs while under load (blades engaged) good
BUT
When it's on high throttle there's the odd popping/misfire sound here and there
How can I fine tune that issue without wrecking the others?
I have idles around 1800rpm low/3000 high
It idles great on low
It runs while under load (blades engaged) good
BUT
When it's on high throttle there's the odd popping/misfire sound here and there
How can I fine tune that issue without wrecking the others?
1 - 4 of 7 Posts
- It was broken, so I had to fix it...I replaced the carb completely
And I don't believe its supposed to make a popping/misfire sounds on a new carb, so I'm fixing it
So if it's making this type of noises on a new carb, would it be more fuel or less in the mixture needed?
Thanks Dwendt
1 - 4 of 7 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
My Tractor Forum
A family friendly forum community dedicated to all Tractor owners and enthusiasts. Come join the discussion about specifications, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
