My Tractor Forum banner

Briggs 6.75 HP Not Priming

1541 Views 10 Replies 4 Participants Last post by  hankll
This is on a Troy built push mower.
engine number, 125K09-0266-E1,
I cant get the primer to push the fuel to the carb.
What I have done to far;
rebuilt and cleaned carb, Replaced float valve and seat, replaced primer bulb.
I know the holes arent clogged cause if I take the straw from a can of carb cleaner and blow into the hole where the primer pushes the fuel, the fuel comes out in the carb, like its suppose to.
I have even used 2 gaskets between the air filter housing and the carb, as suggested by local small engine repair shop.
With the primer housing/air filter housing off, I hold the gasket tightly onto the housing with fingers and pump primer bulb, I can feel and hear the pushing through the hole like its suppose to. But when I assemble everything back together, it wont push the fuel into carb.
After much pulling of the rope and shaking the mower to get fuel into the carb, eventually it will start. Once its started it runs like a new mower, its just getting it started thats the problem.
The only thing I know left to try is replacing the housing with the primer bulb?

Any thoughts before I do that?
1 - 1 of 11 Posts
No or low compression would be the problem there! Good catch!
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.