The carb bowl will fill with fuel irrespective of that carb solenoid position. The solenoid will just prevent fuel from entering the main jet to the intake.
Briggs 17HP Fuel Pump?
I have a 17Hp Briggs 310707-0137-E1 and just replaced the carburetor (new) and turned over the engine. It appeared that fuel was leaking out of the carb throat. I did not have the housing completely assembled and was wondering where is the fuel pump? The line goes from the tank, to the filter, to the carb. Is this gravity fed?
I replaced the filter (small disc type) with a larger domed shaped one. Also, my old carb had no solenoid attached to the bowl and my new one does. There is the two prong wire coming from the engine. Should I connect the solenoid, remove it, or what?
Thanks much in advance!
I’m awaiting a new starter for this engine as it’s totally rusted tight inside. Must be the original and PO was whacking at it pretty good.
I replaced the filter (small disc type) with a larger domed shaped one. Also, my old carb had no solenoid attached to the bowl and my new one does. There is the two prong wire coming from the engine. Should I connect the solenoid, remove it, or what?
Thanks much in advance!
I’m awaiting a new starter for this engine as it’s totally rusted tight inside. Must be the original and PO was whacking at it pretty good.
1 - 1 of 10 Posts
1 - 1 of 10 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
My Tractor Forum
A family friendly forum community dedicated to all Tractor owners and enthusiasts. Come join the discussion about specifications, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
