Briggs 16 hp dipstick length needed

1598 Views 13 Replies 6 Participants Last post by CrazyVet, Jan 19, 2012

Richard-tx

Discussion Starter · Jan 17, 2012

I need the length of the dipstick from the top of the metal cap to the "FULL" mark on a 16hp single cylinder Briggs engine. The PO broke the dipstick, repaired it and never affixed the cap on the stick. As a result depending on where the cap is located, it is either overfilled by a quart or a gallon low or somewhere inbetween.

Code:

                              [U]Current Inventory[/U]
   24G (Onan 24hp)    24GLX - was 16G  (Onan 24hp)   8249 - was 8129 (Onan 24hp)
        818T (Onan 18hp B48)       8163T - was 8123 (Onan CCKA) 
                              8183T (Onan B48)
   5665 w/brakes        5665        5660        Pro-8         Pro-16 w/brakes

For Gravely Manuals and more visit [url]http://GTCOA.com[/url]

Save

1 - 3 of 14 Posts

al b

· #5 · Jan 17, 2012 (Edited)

Is this the dipstick that goes to the top of the cylinder head? I have one here that is about 17 inches. Is it the one you need? this one is top of cap to full mark is 15.5 and add is 16.3/16.

Save

al b

· #11 · Jan 18, 2012

Is it part # 523?
http://oldgravelys.net/pdf/Briggs_326400_TO_326499_IPL_19851000.pdf
I posted those measurements last night.

Save

al b

· #12 · Jan 18, 2012

I just looked up OldGravelys.net and it could be one of 4 different numbers/ dipsticks. 2 long ones, a medium one and a short one. Which one are you looking for Richard?

Save

1 - 3 of 14 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month