Briggs 16 hp dipstick length needed

1597 Views 13 Replies 6 Participants Last post by CrazyVet, Jan 19, 2012

Richard-tx

Discussion Starter · Jan 17, 2012

I need the length of the dipstick from the top of the metal cap to the "FULL" mark on a 16hp single cylinder Briggs engine. The PO broke the dipstick, repaired it and never affixed the cap on the stick. As a result depending on where the cap is located, it is either overfilled by a quart or a gallon low or somewhere inbetween.

Code:

                              [U]Current Inventory[/U]
   24G (Onan 24hp)    24GLX - was 16G  (Onan 24hp)   8249 - was 8129 (Onan 24hp)
        818T (Onan 18hp B48)       8163T - was 8123 (Onan CCKA) 
                              8183T (Onan B48)
   5665 w/brakes        5665        5660        Pro-8         Pro-16 w/brakes

For Gravely Manuals and more visit [url]http://GTCOA.com[/url]

Save

1 - 1 of 14 Posts

Jimmy in NC

· #9 · Jan 18, 2012

I can get pictures and measurements when I get home today if you still need them Richard. There is a bend in the dipstick too.

Save

1 - 1 of 14 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month