My Tractor Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Good evening everyone. Been reading for a few weeks now and couldn't find what I was looking for.

Question for the old Bobcat gurus out there or just someone that has a Bobcat 500 with the Kohler K662.

I've decided to finally retire the old Kohler and repower my M500. I am reseaching what I need and I am looking for either the variable speed pulley inner diameter and key size or the outer diameter of the Kohler K662 crank snout and the key size. From reading I am thinking the original snout is 1 7/16" with a 3/8" key?

Does anyone know of a good place for a bushing to go fro a 1" crank with a 1/4" key to a 1 7/6" pulley with the 3/8" key?


thanks in advance
Rob
 
1 - 1 of 1 Posts
Top