Blade position on Duraforce

1660 Views 9 Replies 7 Participants Last post by RfWi, Dec 3, 2018

Dave Hill

Discussion Starter · Nov 25, 2018

Hi Everyone:

I have found recommendations for mounting a blade parallel or perpendicular to connecting rod at top dead center for C & D engines, but have not seen anything regarding the Duraforce engine.

Is anyone aware of any directions from Lawn-Boy on how to position the blade on a Duraforce?

Thanks
Dave

Save

1 - 2 of 10 Posts

Dave Hill

Discussion Starter · #6 · Nov 27, 2018

Thanks Guys.

I thought I saw an old post pertaining to the blade position on a Duraforce on this forum, but the search function did not reveal anything. Mind you I don't think the search feature on this forum works as well it it once did.

I positioned the blade parallel to connecting rod when piston is at TDC and made a note so I remember this in the spring. If it vibrates I'll change position 90 degrees.

Thanks

Save

1 - 2 of 10 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month