Blade position on Duraforce

1665 Views 9 Replies 7 Participants Last post by RfWi, Dec 3, 2018

Dave Hill

Discussion Starter · Nov 25, 2018

Hi Everyone:

I have found recommendations for mounting a blade parallel or perpendicular to connecting rod at top dead center for C & D engines, but have not seen anything regarding the Duraforce engine.

Is anyone aware of any directions from Lawn-Boy on how to position the blade on a Duraforce?

Thanks
Dave

Save

1 - 1 of 10 Posts

ReedZ

· #5 · Nov 27, 2018

Bill,
I'm also in agreement with you on the older models. I've definitely cured excessive vibration by moving the blade perpendicular to the piston.

G

Save

1 - 1 of 10 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.