My Tractor Forum banner

Blade position on Duraforce

1663 Views 9 Replies 7 Participants Last post by  RfWi
Hi Everyone:

I have found recommendations for mounting a blade parallel or perpendicular to connecting rod at top dead center for C & D engines, but have not seen anything regarding the Duraforce engine.

Is anyone aware of any directions from Lawn-Boy on how to position the blade on a Duraforce?

1 - 2 of 10 Posts
Thank you gentlemen. Anything I can learn about the F series is greatly appreciated. :D
I read somewhere that blade on F engine was set parallel to rod,D perpendicular as mentioned previously.
Yes, you are correct. I always remember it by relating parallel to the two lines in the letter "F".
My memory device is the d in perpendicular and D engine,not in parallel and F.:tango_face_wink:
1 - 2 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.