My Tractor Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,382 Posts
The seat is driven out with a punch and hammer. Remove plug #1 and drive it from there. Getting the new one in is the tricky part if doing without removing the pump. You need to use a driver with diameter slightly smaller than the seat so the seat is not damaged. Do you have a pressure gauge to adjust pressure after installation? Pressure should be 2250 psi.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top