My Tractor Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
I have 1630 -79 with an eigthport hydraulic pump.
At idle RPMs are there a distinct banking noise from the hydrulic pump, when reaching 8-900 rpms, it ok.
When using a pressure gauge, the pressure varies a lot at idle, but steady at higher rpms.
Seemes like the hydraulic is working ok, there is enough oil, and oil was replaced the other year.
An old mechanic said it was a valve in the pumpe which made the noise.

I was thinking of an overhaul, replacing worn pistons, springs, valves and so on. The hourmeter read 6200 hours.
Any suggestions what to do?
What are the most likely valves to make this noise?
 

Attachments

·
Registered
Joined
·
14 Posts
Discussion Starter · #3 · (Edited)
Re: Hammering/rattling sound from hydraulic pump on 1630

Thanks a lot! Sorry for my english, hammering or rattling are correct phrases yes!

Thats the problem valve, ok, I'll order new parts next week.
Its actually shown on my drawing as well I think (26-27) but it dosen't show where it goes into the pump. I think you got the numbers a little wrong, the seat is 11 and valve is 14, the guide (which don't need replacing?) is 15.

There were some parts missing in my drawing yes (from a part catalog from a local dealer in Norway), but I found the correct drawing on JD part catalog online now, where I can see the complete valve.

Thanks again, I'll let you know how it goes when I have replaced the seat & valve.
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #4 ·
At last I found time to replace the parts, but I could not get seat out.
I assume it should go out the same way as the valve & spring, and I tried to knock it out carefully with a small hammer, but no.

Any suggestions?
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #6 ·
Yes, I removed Plug #1, but I didn't punch it hard, I'll try again.
I replaced the vavle yesterday (but not the seat), adusted to 155 bar (2250 psi), but the hammering noise was still there.
The old valve was not very worn, just a small "ring" where the valve meets the seat.
Don't know how the seat is though.
Have a pressure gauge yes, but I connect it to the connection on back of tractor, should be the same presssure there I think.

Could the noise come from the engine vavles?
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #7 ·
I got the seat out ok, but was unable to get it back in, so I had to dismount the pump.
Then I found whats probably making this hammering sound; the drive shaft is damaged, the rubber dampeners are gone and only one of the two bolts which goes into the motor, are there.

New parts are ordered.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top