I have never worked on my tractor yet but have done this on cars. if you have a wood lathe you can take caliper adjustment off the transmission shaft and turn a clutch alignment tool on the lathe.
B7100 HST front axle U-joint question
I split the Kubota this week and have a couple of questions maybe someone can answer.
![]()
One of my questions is the U-joint cover in the pic below when I removed it was full of 80/90 lube. There is no fill or drain for this and I assume you have to keep it lubed due to no grease zerk on it. Do you just pour lube down the neck of it after reinstalling it? It has a seal on the front and then the driveshaft tube seal on the rear and was not leaking before but I want to make sure the rear front axle seal is not bad and blowing the lube into the cover. I cannot find anything in the service manual about adding lube to it.
![]()
Second question: The large bellhousing seal is $41 and wondering if its purpose is to keep dust out of clutch housing?
Third question: Can you buy a clutch alignment tool? I am swapping flywheel and clutch assy's to new motor.
thanks!
One of my questions is the U-joint cover in the pic below when I removed it was full of 80/90 lube. There is no fill or drain for this and I assume you have to keep it lubed due to no grease zerk on it. Do you just pour lube down the neck of it after reinstalling it? It has a seal on the front and then the driveshaft tube seal on the rear and was not leaking before but I want to make sure the rear front axle seal is not bad and blowing the lube into the cover. I cannot find anything in the service manual about adding lube to it.
Second question: The large bellhousing seal is $41 and wondering if its purpose is to keep dust out of clutch housing?
Third question: Can you buy a clutch alignment tool? I am swapping flywheel and clutch assy's to new motor.
thanks!
2
