My Tractor Forum banner

1 - 2 of 2 Posts

·
New B-10 Owner
Joined
·
45 Posts
Discussion Starter #1
I took my 64 b10, with the B&S 23D, all the way apart and made the classic missing a "before" picture. I can't figure out where the speed cable connects.
The cable goes from the lever and connects along the way atop the the carb, but I can't see, and can't remember, what the end cable should be attached to??

It is attached at the carb and there just doesn't seem to be anything in reach? Does anyone know where there is a diagram or am I missing something obvious?
 

·
Registered
Joined
·
21 Posts
Choke goes along the bottom inner side of carb, secured in with small hex screw/washer. Throttle should come down along the top, secured to bracket on top of intake manifold, and the wire end should go into hole on vertical throttle shaft/rod linkage on innder side of carb.
 
1 - 2 of 2 Posts
Top