Thanks Marc I went ahead a got a couple of seals. now I see how the newer ones are put together. I was thinking the thrust bearings or bronze thrust washers 1" ID 1/8" thick they would take out the slop but not rust up like the thrust bearings.
Axle seal for 800/8000 G series?
Does anyone have the seal P/N for the rear axle seal on a 816. I'm getting ready to install the rear PTO axle block and the bad seal I'm replacing was a metal housing but I'm looking for the newer mostly rubber seal used on the newer G series. Also does the rear PTO shaft that goes in the axle block always have alot of play front to back. The axle block measures 4" and the shaft measured between the washers and retaining clips is 4.25" so the shaft can move 1/4" front to rear. Is that normal or is something missing or worn out? Thanks Jason
1 - 4 of 11 Posts
I had a few of these seals and thought I had the number wrote down but now I can't find it and have already installed the seals I had so I can't look at them. Does anyone have the part number handy? JasonDoes anyone have the seal P/N for the rear axle seal.I'm looking for the newer mostly rubber seal used on the newer G series. Thanks Jason
Help? Anyone?I had a few of these seals and thought I had the number wrote down but now I can't find it and have already installed the seals I had so I can't look at them. Does anyone have the part number handy? Jason
1 - 4 of 11 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
My Tractor Forum
A family friendly forum community dedicated to all Tractor owners and enthusiasts. Come join the discussion about specifications, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
