Most of the time there is no bearings to change.
You need to buy another block.
You need to buy another block.
at a loss please chime in
ok the hh120 that had a bad knowck after piston and rings heres the lates
I tore it down pulled the piston pulled the crank pulled the cam all MIC out to spec. I did notice that it looked as if the mag on the flywheel was hitting the ssi ???? not sure how thats posible but could that be my knockin noise
I tore it down pulled the piston pulled the crank pulled the cam all MIC out to spec. I did notice that it looked as if the mag on the flywheel was hitting the ssi ???? not sure how thats posible but could that be my knockin noise
1 - 1 of 18 Posts
1 - 1 of 18 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
My Tractor Forum
A family friendly forum community dedicated to all Tractor owners and enthusiasts. Come join the discussion about specifications, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
