My Tractor Forum banner

at a loss please chime in

2079 Views 17 Replies 7 Participants Last post by  lbyeah
ok the hh120 that had a bad knowck after piston and rings heres the lates
I tore it down pulled the piston pulled the crank pulled the cam all MIC out to spec. I did notice that it looked as if the mag on the flywheel was hitting the ssi ???? not sure how thats posible but could that be my knockin noise
1 - 1 of 18 Posts
centrigugal force would almost keep them on- they only need to ke stuck lightly to the flywheel to keep them from sliding around.
1 - 1 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.