My Tractor Forum banner

Ariens GT19 Electric PTO question

963 Views 1 Reply 2 Participants Last post by  jaynut
I have an Ariens GT19 which I scrapped the engine (It was garbage) but now I'm not sure what size shaft it had for the electric pto.The inner diameter of the pto looks like 1-1/4 inches but I'm wondering if the original may have had a spacer which I don't have.I want to put a magnum m18s I have on the tractor but the shaft size is only 1". So am I missing a spacer or was the original shaft size 1-1/4 inches. (I wish I wasn't in such a hurry to clean the garage out before winter then I would've kept the original motor a little longer). Thanks!
1 - 2 of 2 Posts
you will need a shaft bushing, I had to get one when I did an engine swap on my gt14
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.