My Tractor Forum banner
1 - 4 of 4 Posts

· Registered
1936 Allis Chalmers WC
Joined
·
52 Posts
Discussion Starter · #1 ·
Hello there. So im a farmboy who accuired an 1936 (Unstyled) Allis-Chalmers WC back in 2012. But a few days ago while touring an old collapsed barn in a parts yard, i found an old rusty and orange toolbox with "WC" written on it. A little research only brought upp that it was a frame mount box, its made with a divit in it for mouting, it doesnt go on the fender. Im curious if anyone knows where it would go on the tractor, i havent found any holes that line up, or maybe if it goes on a styled one.
 

· Administrator
Joined
·
18,616 Posts
Here is a link to a discussion w/photo of toolbox on rail on AC forum.. Have to study it to see as bit hard to see.
Ideas for tool storage on a tractor?
Doing a search turns up several links.
Here's a link showing one on Farmall in same place. BTW, can do so on either, or both sides as some mentioned. Primarily used for grease gun and fire extinguisher plus whatever else needed in field.
http://www.tractorshed.com/gallery/uptest/a32413.jpg
MikeC
 

· Registered
1936 Allis Chalmers WC
Joined
·
52 Posts
Discussion Starter · #4 ·
Here is a link to a discussion w/photo of toolbox on rail on AC forum.. Have to study it to see as bit hard to see.
Ideas for tool storage on a tractor?
Doing a search turns up several links.
Here's a link showing one on Farmall in same place. BTW, can do so on either, or both sides as some mentioned. Primarily used for grease gun and fire extinguisher plus whatever else needed in field.
http://www.tractorshed.com/gallery/uptest/a32413.jpg
MikeC
Thank you a lot, been trynaa figure out where it goes,
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top