My Tractor Forum banner

990 wont crank

1344 Views 10 Replies 4 Participants Last post by  990tank
i had the thing cranking fine before i took the starter off now its back on and everythings wired and grounded correct and it wont crank at all:00000060:
1 - 3 of 11 Posts
hit it with a hammer, its a good heavy starter it can take it. :Stop:
its easy to jump the solonid or starter relay on most riding mowers. you can also measure if voltage is getting to the relays coil. Might work better than a hammer
:sidelaugh but no seriously, some of the starters on the opposed biggs after they sat for a while, you could rap on them witha hammer and they would starter to work again. usually not a permanent fix.
1 - 3 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.