My Tractor Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
110 Posts
Discussion Starter · #1 · (Edited)
After looking around for a long time and unable to find a factory blade, i decided to undertake a build, this thread follows that journey.

A ginormous THANK YOU to VTXRider for all the dimensions off his factory plow and a ton of extra questions answered......I may still have a few before I'm done.

Here are the images to the components.
I decided to use an existing blade i have and build the rest based on the drawings below.





 

·
Registered
Joined
·
110 Posts
Discussion Starter · #5 ·
BINGO! I just scored a 54" wide plow blade only and pivot bracket off a 190-985-000 MTD blade that was on a sears gt18 with a modified mount.
Cutting edge is good and skids are like new! Same as the original 990 blade.
Still ordering steel and need to fabricate the hanger and mounts but this is a sweet suprise!

Side note: Is there a limit on number of albums and pictures for non-members?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top