User Wesley had some questions about the two control rods on the right side of the plow - here are some pictures with rough dimensions.
Click any of them to get a large view.
I tried to use Autostitch to make these three pictures into one, but it couldn't do it. The forum won't post them side by side either, but hopefully you get the idea.
Closeup of the angle lock release "pedal".
I simply have it hooked over the other rod, but the original bracket has two holes and positions the lock release closer to the footboard. Here's a picture that the PO of my blade took before he sent me the bracket - I had forgotten to get it when I bought the blade. Even this may be a home made solution.
Here's a picture from the owner's manual showing a different but similar bracket:
The angle rod has a ball on the end to make it easier to push/pull:
Here is the length of the "pedal" for the lock release rod:
...and, the width:
Here is the length of the lock release rod:
Here is the length of the angle rod:
Each rod has a short 90° bend where it attaches to the plow, about an inch. There is also a hole drilled through it for a cotter pin. This is the angle rod:
...and, the lock release:
Both rods are 3/8" diameter. That would make the threads on the ball most likely 3/8"-16 NC.
Hope that helps - if you need more info, let me know.