My Tractor Forum banner

8n electric wiring harness tube

6484 Views 8 Replies 5 Participants Last post by  SandDawg
ok i am going to replace the wiring harness on my 8n, the wires are just old. They are in the metal tube that runs down the block my question is when i go to remove that tube will the blots that are holding it to the block need to be torqued like a normal head bolt would, or is just to hold that tube on to the tractor.
1 - 1 of 9 Posts
fishing the wires through didn't work for me.
i got to the 4th pug wire and i didn't dare put to hard to wreck my new wiring harness.
after my effort i just zip tied the new harness to the outside of the wiring loom.
That is also what I did. I could not get all the wires back into the tube. It works fine.

1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.