8n electric wiring harness tube

6489 Views 8 Replies 5 Participants Last post by SandDawg, Dec 10, 2011

met828

Discussion Starter · Dec 4, 2011

ok i am going to replace the wiring harness on my 8n, the wires are just old. They are in the metal tube that runs down the block my question is when i go to remove that tube will the blots that are holding it to the block need to be torqued like a normal head bolt would, or is just to hold that tube on to the tractor.

Save

1 - 1 of 9 Posts

bow2no1

· #6 · Dec 10, 2011

i like the exhaust pipe idea!

fishing the wires through didn't work for me.
1st i tied string to the wires and taped the wires so they wouldn't fetch up on the pug wires on the way through. i got to the 4th pug wire and i didn't dare put to hard to wreck my new wiring harness.
after my effort i just zip tied the new harness to the outside of the wiring loom.

Save

1 - 1 of 9 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month