well i not only did the wires need to be replaced but i think the one bracket that goea to the tube has rotted off and i was going to braze/ tach weld it back on there
8n electric wiring harness tube
ok i am going to replace the wiring harness on my 8n, the wires are just old. They are in the metal tube that runs down the block my question is when i go to remove that tube will the blots that are holding it to the block need to be torqued like a normal head bolt would, or is just to hold that tube on to the tractor.
1 - 2 of 9 Posts
1 - 2 of 9 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
My Tractor Forum
A family friendly forum community dedicated to all Tractor owners and enthusiasts. Come join the discussion about specifications, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
