My Tractor Forum banner

8n electric wiring harness tube

6488 Views 8 Replies 5 Participants Last post by  SandDawg
ok i am going to replace the wiring harness on my 8n, the wires are just old. They are in the metal tube that runs down the block my question is when i go to remove that tube will the blots that are holding it to the block need to be torqued like a normal head bolt would, or is just to hold that tube on to the tractor.
1 - 2 of 9 Posts
ok i am going to replace the wiring harness on my 8n, the wires are just old. They are in the metal tube that runs down the block my question is when i go to remove that tube will the blots that are holding it to the block need to be torqued like a normal head bolt would, or is just to hold that tube on to the tractor.
Why remove it ?? Its not that hard to fish the wires through..
That is also what I did. I could not get all the wires back into the tube. It works fine.

Red
Fish mine through about 3 times over the past 12 years..No problem..
1 - 2 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top