My Tractor Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a chipper that has a 8 hp hm80 engine I was told that a 10hp engine would be the same. I need to know if the mounting and the height where the chipper blades mount would be the same. Any help would be appreciated.
Mike
 

·
Retired Super Moderator - Deceased September 2015
Joined
·
26,679 Posts
:MTF_wel2: Glad you joined!
:wwp: If you need easy Picture help
Be sure to Register for Your State!
 

·
15,000 +posts!
Joined
·
20,545 Posts
I'm pretty sure that an HM80 and a HM100 are the same block,so it should bolt up OK...
You might be able to get a better idea of the mounting patterns and crank height by going to the Northern Tool website or the Surplus Center,they have "technical info" on their sites that list the dimensions...
 
1 - 3 of 3 Posts
Top