My Tractor Forum banner

800 Rider clutch parts

1018 Views 4 Replies 4 Participants Last post by  stovebolt
First post, bear with me.
Need parts to repair reverse clutch, the clutch plate and 3 rollers. I see Cogan Brothers Machine makes these parts. Has anyone dealt with these folks or have a recommendation for another source?
1 - 1 of 5 Posts
I needed a few of the old style (the old two piece style doesn't wear out the plate) so I made some. Not only were they easy to make but quick as well.

Materials needed:
1 pc - 1/4" x 36" oil hardening rod - $2.57
1 pc - 1/2" x 36" oil hardening rod - $8.39

I used about 1 ft of material making 18 of them.

Tomorrow I will heat them and then dunk in some oil motor oil to harden them. It took me a little over an hour to make them.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.