My Tractor Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter #1
I have been looking for a used 62D forever I can not find one, I found a used 62c for sale and I am wondering if it will cut as nice as a 62D? Do you know what the differences are in between the two?

Thanks Jordan
 

·
USMC
Joined
·
19,146 Posts
62C is a regular belly type mount you have to roll under the tractor and attach by hand. The 62D is a drive over deck. Both are excellent decks. slkpk
 

·
9K+ Poster
Joined
·
12,160 Posts
You can't go wrong with either. Here's a pic of the cut quality:

 

·
Registered
Joined
·
344 Posts
I love seeing that picture! Now mow it again the other direction and take another pic!!! Back to the OP, either deck will cut real nice. I have the 62C deck. I installed a set of factory high-lift blades, the anti-blowout kit, and I have my deck perfectly levelled side-to-side (with the powerflow attached) and the front of my deck will cut exactly 1/16th of an inch higher than the height-of-cut indicator shows, and the rear of the deck is 1/4 higher than the front. I mow at full throttle at all times. I keep the underside of my deck scraped down. I keep my blades razor sharp when I can.
 

·
Registered
Joined
·
2,768 Posts
If memory serves you have a 2320 do you not? And that being said you need the 62D as the 62c according to Deere is not compatible with the 2320..
 

·
9K+ Poster
Joined
·
12,160 Posts
If memory serves you have a 2320 do you not? And that being said you need the 62D as the 62c according to Deere is not compatible with the 2320..
Good point!

and unit40; thanks! :)
 

·
Registered
Joined
·
34 Posts
Discussion Starter #7
I guess I can not take the sellers word that it will fit my 2320. It is off a 2210, I wonder how much fab work it wil take to fit mine?
 
1 - 7 of 7 Posts
Top