My Tractor Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
162 Posts
Discussion Starter #1
Hi,

I (now) have 2 44 decks with 4 good spinles- or at least 4 blades that don;t rock around. I got the locknut off. The pulley seems splined to the shaft (good!) and I assume the hex head on the pulley is to hang on to while you get the locknut off.

Soo.. how do you get the pulley off the shaft without trashing the zerk? Do I gotta trash the zerk and get new ones? If so, where do you get em?

Also-- seems like I gotta split the nuts on them 3 bolts that hold the spindles on.

On another note, where can I *see* the diff between 44A and C and whatever other models of 44" deck there were?

Best,

Bill
 
1 - 1 of 1 Posts
Top