Good to hear that it worked out for ya.
42" Snowthrower
I'm working on a 42" Snowthrower, and the auger is belt drive. Under the black cover on the side of the housing is a large auger drive pulley, an idler, a drive pulley, and a belt. I took the cover off to see the condition of the belt and I noticed that the large pulley is warped. It wobbles when the auger is spun. Not just a small wobble either. I'd say it travels 3/8" to 1/2" either direction of center during one revolution. It's so bad that it cut a groove/hole in the side of the black plastic cover. The pulley in question is part # 18 in the diagram below.
My question is, since this is a $50 part ($75 from mother Deere), is there any way to straighten a pulley or am I out of luck?. I'd let it go but from the look of it the belt will wear fast in it's present state. I think the unit must have taken a hit to that side at some point to do this, or maybe the auger hit something and the pulley took the punishment because it's in the drive train.
My question is, since this is a $50 part ($75 from mother Deere), is there any way to straighten a pulley or am I out of luck?. I'd let it go but from the look of it the belt will wear fast in it's present state. I think the unit must have taken a hit to that side at some point to do this, or maybe the auger hit something and the pulley took the punishment because it's in the drive train.
