My Tractor Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
977 Posts
Discussion Starter #1
next to my oil filter for the Briggs engine, their is a small boot thats threaded in to the housing, is this for a oil pressure gauge? where can I find something like that?
was thinking a small one that I could just screw in at the end, I dont want to cut up my ingys dash.
 

·
Registered
Joined
·
2,577 Posts
What do you mean by " small boot " ? If it is a 1/8" or 1/4" pipe thread then it most likely is a pressure port for a guage. 0-60 psi guage should work. I think they run about 30 psi...
 
1 - 2 of 2 Posts
Top