[ronsdeal]

Hi All;
Been rebuilding my 84 318, [B43g conversion to a B48g] thank you Boomer!
I am asking because I am forgetting how the oil pressure sending unit wire is ran from the sending unit to the 3 pin connector.
i.e. where in the shroud?
Thanks...................and I'm not forgetting that I will have more questions as this build progresses.
Regards
Ron

 

[eric71m]

Hi All;
Been rebuilding my 84 318, [B43g conversion to a B48g] thank you Boomer!
I am asking because I am forgetting how the oil pressure sending unit wire is ran from the sending unit to the 3 pin connector.
i.e. where in the shroud?
Thanks...................and I'm not forgetting that I will have more questions as this build progresses.
Regards
Ron

B43g to a B48g???? Please tell me what that is?


Sent from the MTF Free App

 

[boomers_influence]

ron
look at the top of the block, above the oil filter.
in the corner, you will see a hole cast into the block.
the wire goes through the hole.

eric
the change from B43G to B48G,
involves a different crank, rods and main and idle jets for the carb.
ron now has a 20 h.p. engine.
thank you. boomer ( the used onan engine parts guy )

 

[ronsdeal]

Thanks Boomer, and also for the explanation on the conversion!!
Bob;I'll keep you posted on the progress.
Ron

 

[eric71m]

ron
look at the top of the block, above the oil filter.
in the corner, you will see a hole cast into the block.
the wire goes through the hole.

eric
the change from B43G to B48G,
involves a different crank, rods and main and idle jets for the carb.
ron now has a 20 h.p. engine.
thank you. boomer ( the used onan engine parts guy )

Cool I gotta hang on to this one!


Sent from the MTF Free App