My Tractor Forum banner

300 H2 to H3

1993 Views 5 Replies 4 Participants Last post by  jseim
How hard is it to put an H3 valve off a 400 onto a 300? I have it stripped down right now for painting and engine overhaul. Just curious if alot of fabricating had to be done or if it was pretty much bolt in.

1 - 1 of 6 Posts
I just looked at the parts on and the valve levers looks VERY similar if not identical. The "Bearing" as they call it...........the piece that the levers actually slide through is the same part number......that much I know.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.