My Tractor Forum banner
1 - 3 of 3 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
Thanks to the guys that sent the wiring diagrams!Unfortunately they were the wrong ones,so I probably gave wrong info on my Cub.
Here it is:2000 series Cub Cadet:13A-212F100,377873,eng CH13S,spec no-22508.Hydro drive 13hp with the Kohler horizontal shaft.
Here's the problem:when I got this mower,the black wire on the pto switch was hooked up to the negative battery post.When I tried to start it,the inline fuse blew.I disconnected the black wire from the battery,and now it runs,and does'nt blow the fuse,but the pto does not work.I cannot figure out where that black wire is supposed to go.
All the other wiring seems to be right.
Sorry for the confusion!
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.