My Tractor Forum banner

140 H1 snow blade ?

2288 Views 8 Replies 4 Participants Last post by  Cementhead
I got single cylinder 54" snow blade for my H1. Waiting for snow. The question I have is, does my tractor have a float position for the blade? Do I need that?
1 - 1 of 9 Posts
The H-1 does not have a float position but the blade does. Look at where the pin goes where the lift cyl. is attached to the mount there are two position's for the pin one allow's you to put down pressure on the blade the other allow's the blade to free float. Hope this help's .BILL
Is it the slot in the first pic? Or the oblong hole in the second pic?
Motor vehicle Vehicle Auto part Car

Vehicle Wire
See less See more
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.