My Tractor Forum banner
  • Are you passionate about Tractors? Would you like to write about topics that interest you and get paid for it? Read all about it here!
rpm
1-4 of 4 Results
  1. Lawn and Garden Tractor Accessories
    Hello! We've just acquired an OK condition Mott 60" flail mower - pics attached. Plan to run it behind a John Deere 455 garden tractor. It needs a few things but everything turns smoothly without obvious problems, so the main thing I want to figure out is its RPM needs... I suspect this mower...
  2. John Deere Forum
    I was hoping someone could point me in the right direction on what the correct engine speed under load should be. I recently finished an overhaul on the 590V (900 hrs), new rings, metal cam gear, oil/water pump gear, governor, gaskets, etc and have put the deck and powerflow back on. I followed...
  3. Simplicity/Allis Chalmers Forum
    After replacing both ignition coils on Kohler CH740 the tach needle sits on 4000 RPM engine running. Key on engine off tach sits at 0 RPMthen while cranking and engine start the tach climbs to 4000 while actual engine RPM is at base idle. What is the tach input signal? Thinking about installing...
  4. Cub Cadet Forum
    I just purchased my Cub Cadet XT1 two days ago from Home Depot. It was still crated and I assembled myself. Mower was used to cut about an acre, cleaned and stored under a shed with a cover. New gas can and fresh gas used from the start. Air filter is clean. Went out today to do more mowing and...
1-4 of 4 Results
Top