Search Results for ‘kohler’

I own a Gravely 16G garden tractor, with a Kohler 18s (18hp) engine on it. I bought it brand new in 1994. After all this time, the engine blew. So last year I found and bought a used tractor that's identical to mine. That owner said he bought his tractor in 1995. Well, it's engine blew...

Purchased 3 non working mowers all for $150 (JD 125, JD LT160, Husqvarna lgt2654) I have the 125 working with just simple maintenance parts and replaced the carb. I had the LT 160 running just before I transported it to my moms house (10 min in city). It would not start once unloaded. What...

So when I built my house I installed a Kohler RDT-CFNC-200ASE transfer switch and had planned on a Kohler natural gas unit until recently losing gas service during a freeze. I ended up purchasing a Diesel Cummins-Onan 50DGCA rated at 33kw single phase. I am trying to figure out how to wire the...

So when I built my house I installed a Kohler RDT-CFNC-200ASE transfer switch and had planned on a Kohler natural gas unit until recently losing gas service during a freeze. I ended up purchasing a Diesel Cummins-Onan 50DGCA rated at 33kw single phase. I am trying to figure out how to wire the...

Hello! First post here on MTF. Thanks in advance for your help! I have a mini skid steer with a Kohler Ch640 engine. I am doing head gaskets on it. It is an engine model with the head studs instead of head bolts. Unfortunately, the body of the skid steer is too tight for me to be able to...

Hello all, new to the fourm so trying to figure all the controls out still. But anyho I have a 79 John Deere 317, for a while it wasn't running, I went through the carb, changed the oil and checked a few other things and got it running again, but ever since then I've had problems with the...

Hello, I’m new on here and I was hoping I could get some help! I have a 1990 Duetz Allis Sigma 1817 with a 17 hp Kohler magnum (mv17). I would like to find an engine rebuild kit but I’m not having much luck. Any help would be greatly appreciated! Hunter

Looking to buy a Cub Cadet 42" for my small yard (in Western PA with sometimes thick, wet grass on a slight slope). Any comments/recommendations on the Intellipower engine vs. the Kohler or are they basically same same? The Intellipower is $200 cheaper at the big box stores.

I got a kohler magnum 20hp in a deutz allis 1920/simplicity sunstar 20. I've read that a kohler k582 camshaft would fit in my magnum. Can anyone confirm this?

Hello, I have a Kohler command Ch25 engine that I found out of an abandoned Club cart golf cart. I have rebuilt it and repurposed it for a go kart I am building and I just wanted to check and see if everything sounds like it will work out. The main problem I think i'm going to run into is...

After replacing both ignition coils on Kohler CH740 the tach needle sits on 4000 RPM engine running. Key on engine off tach sits at 0 RPMthen while cranking and engine start the tach climbs to 4000 while actual engine RPM is at base idle. What is the tach input signal? Thinking about installing...

Hey all. I have a 1976 Ariens S-12 with a Kohler K301S 12hp engine. It worked in the warm season but now that everything is frozen, it’s not even trying to start. I’ve checked for spark and I have a pretty one. I tried starter fluid both through the carb and in the spark plug hole and it does...

I have a Bolens 5020H with a Kohler Magnum 20. I need to determine what serial number it is as it seems many parts change with it, but I'm not seeing a model/serial number plate on the engine. can anyone help me if there are other ways to figure this out? My current reason is to find the fuel...

Hello, I just swapped the Kohler CV732-3011 engine (23.5 HP) on my Kubota Z724 ZTR to a Kawasaki FX730V (also 23.5 HP). Please note I didn't purchase new wiring harnesses, conversion kits, etc. as they are very expensive. I just disconnected the wires off the Kubota, installed the Kawasaki and...

Hi All, I need some help diagnosing an issue. This is on an LX255 JD Tractor. Here is he tractor details if it helps: Tractor Data The motor is a 15HP Kohler 426cc 1-cyl gasoline. We had an unfortunate fire under the engine. I think it was just caused by a build up of leaves and other...

Hi, i have a 79 212 that has been sitting for 9 years with a blown head gasket. I sourced a new head (original was warped), and purchased head gasket, carb rebuild kit, other gaskets, ignition switch, points, condenser, plug wire, battery from dealership. I torqued the head per manual, and...