My Tractor Forum banner
  • Are you passionate about Tractors? Would you like to write about topics that interest you and get paid for it? Read all about it here!
ignition
1-7 of 7 Results
  1. John Deere Forum
    Howdy All! I have recently started getting into my making my Deere John 300 workable again. But I’ve run into a roadblock! I can’t seem to figure out how to get the key to start the unit! I have to gap the solenoid with a wrench between the POS and NEG to get it to crank. It won’t crank with...
  2. Simplicity/Allis Chalmers Forum
    After replacing both ignition coils on Kohler CH740 the tach needle sits on 4000 RPM engine running. Key on engine off tach sits at 0 RPMthen while cranking and engine start the tach climbs to 4000 while actual engine RPM is at base idle. What is the tach input signal? Thinking about installing...
  3. John Deere
    I have a 2006 John Deere 2520 compact tractor. After replacing the battery following the owners manual instructions, I go to start the tractor and when I turn the key to the first click (“on”) the starter immideately turns on, motor will turn over, no start. When I turn the key to the second...
  4. Ford/Post 1990 New Holland
    hey so my ignition went shot on my closed side lgt. And I can't seem to find a switch (5 prong) with the right orientation. Does anybody by chance have a wiring diagram for that switch and maybe (even better) have a part number for an after market switch?
  5. John Deere Forum
    I have a John Deere 318 with a P218G. The other day I was mowing. When done, I went to turn the ignition off. Nothing. As a test I turned it the opposite way to start. That engaged fine (made a terrible noise obviously). I removed the battery terminal to shut it down. When I put the...
  6. John Deere
    I've had my JD 2210 for a long time now (17 years) and recently it has developed a strange new problem that has me a bit baffled. When I turn the ignition it starts right up, but when I let the key go it dies. As long as I keep the key turned it keeps going (as in the engine is running), as...
  7. John Deere Forum
    Hi, i have a 79 212 that has been sitting for 9 years with a blown head gasket. I sourced a new head (original was warped), and purchased head gasket, carb rebuild kit, other gaskets, ignition switch, points, condenser, plug wire, battery from dealership. I torqued the head per manual, and...
1-7 of 7 Results
Top