My Tractor Forum banner
idle
1-3 of 3 Results
  1. John Deere Forum
    I was hoping someone could point me in the right direction on what the correct engine speed under load should be. I recently finished an overhaul on the 590V (900 hrs), new rings, metal cam gear, oil/water pump gear, governor, gaskets, etc and have put the deck and powerflow back on. I followed...
  2. Cub Cadet Forum
    My Cub Cadet 2155 won't idle. I replaced the carb, fuel pump, spark plug, and ignition coil. Also check the fuel lines and filter. It seems to be a problem with the governor or linkage. When I turn the throttle all the way down, even when the engine off, I would expect the governor to allow...
  3. John Deere
    According to the instructions, my JD should run at 2700 rpms under load, ie when the PTO is being used. According to the dash, it doesn't; it runs about 2500 rpms when the foot throttle is completely depressed. Should I worry? And if I should, how would one go about adjusting the throttle...
1-3 of 3 Results
Top