My Tractor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-16 of 16 Results
  1. Pit Row
    My Kubota zero turn mower with a 22 hp Briggs & Stratton engine has been sluggish and stalls going up hills. I read several other posts on this forum that point to the carburetor. One symptom that I did not see anywhere else is when I disconnect the fuel line after the pump fuel comes out and...
  2. John Deere Forum
    I replaced the existing carburetor with an inexpensive version. When I put the throttle to choke, it seems it floods and won't start. If I get the throttle adjustment in just the right spot the mower will start, but the engine does surge a bit when running. Has anyone experienced this issue...
  3. Case_Ingersoll_Colt Forum
    Hello folks! I am the proud owner of an Ingersoll 4016 (PIN: 17193107) that has the Vanguard 16 HP V-Twin engine. Only 225 hours on this baby! I have determined through troubleshooting that my intermittent starting issue is being caused by the fuel solenoid on the carburetor and I have...
  4. Generators
    Hi! I was just given this little 550 watt generator and was curious if there was any options for carburetors. I cannot find aftermarket ones and I've tried to clean up the carb. I got it to run cold and then as it warmed up it surged more and more till it died. I'm a automotive mechanic and I'm...
  5. Craftsman/Sears Forum
    I rebuilt the carburetor not long ago and the tractor was running fine, but after sitting for a few weeks it's having some carburetor issues. I pulled the top of the carburetor off and there was only a little fuel in the bottom of the bowl. I bumped the starter and fuel shot out of the hole that...
  6. John Deere Forum
    I'm going to try and kill two birds with one stone here only because I think the two things may be related. When I say the tractor is "running dirty" I mean I think it's running rich, but it's difficult to tell. I believe the smoke is black. It seems to smoke less when not under load such as...
  7. John Deere Forum
    I finally got my carb cleaned on my 317, installed the new gaskets and other parts (float needle, seat, washer, pin, etc.), and installed on the mower. I adjusted the throttle and choke cables. THEN, I remembered that when I was laying the pieces out this morning, that I saw a larger chunk of...
  8. Small Engines and Repair
    Recently got one of these fine engines. Has no carb. I put a carb from another engine and got it to fire. Sounded good. But obviously not the right carb for it. I have the proper intake but not the correct carb. Part # 99876 Anyone have a carb for it?
  9. Cub Cadet Forum
    I'm working on a Cub Cadet LTX 1050 with a Kohler Courage SV725-3021. Not long ago the crankcase flooded with gas as the carburetor float mechanism must have gotten stuck open and the fuel emptied into the engine. Apparently, even with a fuel pump, there was a lot of fuel flow just by gravity...
  10. Gravely
    The original DD13 carb on this engine (on an 8163T i think) is broken - interior pieces of the casting are broken - and I'm having a heck of a time finding the right substitute. I've looked at the Nikki for the B48 and P series but they have a much bigger mounting base which doesn't fit my...
  11. Backyard Round Table: L & G Tractor Related Topics
    Hi, Does anyone know where I can get a Carbuetor for this riding mower? I can't find any that may use the same Carb. It's a Nikky 795450
  12. Small Engines and Repair
    Hello, I have Vanguard 23 hp V-twin vertical shaft engine that I am installing in a Gilson chassie. Type 386777-1021. The engine is from 2008 but have only run a couple of hours (last year as a replacement engine in another tractor) since new. In the new machine the engine does not start. The...
  13. John Deere Forum
    Have a JD210, never owned one before, actually bought 2 but I also am having the trouble of it over reving. I'm not much of a mechanic either so that doesn't help but when I go to start it, it goes _alls to the wall! I can only start it and then shut it down. Any suggestions. Thanks in advance.
  14. Gravely
    Hi my engine has the Marvel Shebler and I'm thinking of two options. One is to rebuild this carb, hollow out the pump body and put on an electric fuel pump. Anybody done that? Other is to find a Nikki with external pump. Uh, where do you find those? I guess last option is to rebuild carb...
  15. Honda
    Can anyone diagnose this non-start issue I’m having with my Honda HT4514? When I first removed the carb there was actually dried fuel flakes filling the float bowl. There was zero gas getting in. I tore the carb down, meticulously cleaned it , and put a Shindy rebuild kit in it. I set the...
  16. Bolens Forum
    I need a replacement carburetor for my bolens G14, i just rebuilt the motor and the needle is no good in the carb so the engine is not getting fuel, it had a Walbro LMH 4-16 on it, if anyone has a known good one or knows a good equivalent that would be great thank you so much!
1-16 of 16 Results
Top