Engine pulley.... - MyTractorForum.com - The Friendliest Tractor Forum and Best Place for Tractor Information

Brick · 04-04-2012, 04:13 PM

Is there any place to find dimensioned specs on no longer made engine pulleys? I had to destroy the pulley to get it off the shaft. I have looked but the part is no longer made. I figured I could make one, if I had the dimensions. The old part # was 756-0303.

I do have one that is close in size, but I am not sure it is the same size. It was bent up a little when someone removed it. I straightened it as best I could on a lathe, bit it is not perfect. What to do.....

Brick

04-04-2012, 04:13 PM	#1
Brick MTF Junior Poster Join Date: Mar 2012 Location: MN Posts: 18 MTF Member # 71179	Engine pulley.... Is there any place to find dimensioned specs on no longer made engine pulleys? I had to destroy the pulley to get it off the shaft. I have looked but the part is no longer made. I figured I could make one, if I had the dimensions. The old part # was 756-0303. I do have one that is close in size, but I am not sure it is the same size. It was bent up a little when someone removed it. I straightened it as best I could on a lathe, bit it is not perfect. What to do..... Brick

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
My Tractor Forum Advertisement

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)