Cam shaft removal on 128? - MyTractorForum.com - The Friendliest Tractor Forum and Best Place for Tractor Information

HoustonatNCSU · 03-13-2012, 08:25 AM

I am in the process of starting a rebuild on the K301 in my 128, have everything torn down except for removing the cam shaft. From what I can tell, the chiltons manual says to drive out the pin from the PTO side. I tapped on it, but it didnt move. Before I apply brute force, is this correct? Are there needle bearings or anything else to be aware of when I pull it out?

badboy1950 · 03-13-2012, 09:19 PM

i just tapped one out of a kohler, there was a plug on the flywheel end.
i used an exacto knife to clean the sides of the hole , sprayed some weasel juice and gave the other end a few good taps.
she came out allright.
Dan

03-13-2012, 08:25 AM	#1
HoustonatNCSU MTF Junior Poster Join Date: May 2010 Location: NC Posts: 23 MTF Member # 43566	Cam shaft removal on 128? I am in the process of starting a rebuild on the K301 in my 128, have everything torn down except for removing the cam shaft. From what I can tell, the chiltons manual says to drive out the pin from the PTO side. I tapped on it, but it didnt move. Before I apply brute force, is this correct? Are there needle bearings or anything else to be aware of when I pull it out?

03-13-2012, 09:19 PM	#2
badboy1950 MTF Member Join Date: Jan 2012 Location: Mass Posts: 61 MTF Member # 69527	Re: Cam shaft removal on 128? i just tapped one out of a kohler, there was a plug on the flywheel end. i used an exacto knife to clean the sides of the hole , sprayed some weasel juice and gave the other end a few good taps. she came out allright. Dan

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
My Tractor Forum Advertisement

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)