i don't know much about the kohlers but i would assume it would... it does have a Kohler, right? Probably just have him message me with the shaft size and distance between bolt holes and I'll check if they match
Hey dreamPuller , I do have the 16hp K341 engine. And I do need the clutch, but the back plate looks a little different then mine. any way you can post a pic here of the back mounting plate?
Guys, I looked in the parts manual and it only lists one PTO clutch for these. Swap info on shaft size and mounting. I hope it works out for both of you.
Shaft size should be 1 1/8" and the back plate will fit just about every small engine out there with that bolt pattern. Shafts will vary, but not the bolt spacing, SAE standard thing going on.
Hello: Do you still have any parts left for the LGT 125 ? Please reply thanks. mobrien@kent.edu
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
My Tractor Forum
4.3M posts
217.1K members
Since 2005
A family friendly forum community dedicated to all Tractor owners and enthusiasts. Come join the discussion about specifications, modifications, troubleshooting, maintenance, and more!