If you have a welder and a drill, it will fit. You have to fabricate a couple of brackets to fit the frame to the loader crossmember, then find a place to mount the supports in front. Then findf a place to mount the fluid resevoir. the pump will mount somewhere you can run a belt to it from youe engine pully. If you can find one that is off a Wheel Horse, you are good, but if you can find another model like a Sears or Deere 216 with a sideways engine, the brackets and hoses might be closer. The red tractor I have with a FEL is a massey/snapper with the front to back shaft driven engine, the yellow one is a cub 100, also with a front to back shaft driven engine. Not sure which you saw.